Preparation：
UC3x Configuration
Step 1: Connect UC3x to ToolBox via USB and make sure the network status is “registered” before adding the device to Milesight Cloud.
Step 2: Set the “Application Mode” as “Milesight Cloud” in “General”. There will be Attention if you go to “Channel” and “Command” page. You can also configure these functions on Milesight Cloud.
Milesight Cloud Configuration
Step 1: register a Milesight Cloud account.
Step 2: After signing into Milesight Cloud, click “Add” to add device on Milesight Cloud.
You will see as below once the device has been added successfully.
Click 
to enter Configuration page and configure the UC3x on the cloud.
You can set different commands via Trigger Settings.
You can check the new firmware version, reboot and transfer devices in “Maintenance” page.
