Q1: Can UC100 transmit data between two RS485 devices (like meter to PLC)?
Answer: Yes, UC100 can be used as Milesight D2D Agent or Controller to transmit D2D commands to trigger actions. For example, connection: it should be meter - RS485 - UC100 ->D2D ->UC100 - RS485 - PLC. Take a RD485 meter and PLC as example, when YC100 reaches a threshold value from meter, it can send D2D command to another UC100 and trigger it to send read/write Modbus command to PLC.
Q2: Does UC300 cellular support to configure remotely?
Answer: Yes, some parameters can be configured via SMS message or remote server. For more details, please refer UC300 (Cellular) Communication Protocol.
Q3: Can I send multiple commands in one downlink to UC300-LoRa? Will all the commands take effect?
Answer: Not support. UC300-LoRa will only execute one command when receive one downlink, other commands will be ignored.
Q4: Can UC51X with hardware version V1.x support to change solenoid interface to 12/9/5 VDC via dip switch?
Answer: Yes it can support changing voltage via DIP switch. Please contact Milesight for details about it.
Q5: If I wire UC300 DO to DI interface, why DI did not activate when set DO to open?
Answer: This wiring does not work. Please refer toHow to wire DI/DO of Milesight controller for the correct wirings.
Q6: Q6: What's the best position to place UC50x to get the better antenna radiation?
Answer: The UC50X's internal antenna is perpendicular with the main board, so it's recommended to place the front of device upwards for better signal.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article